top of page

How to Use Engine Braking to Drive a Manual Transmission Car Down a Hill

Giuseppe Frustaci
Oct 26
11 min read

The short version: How to drive a manual downhill with engine braking. Use engine braking (i.e. let the engine do the work of slowing the car) so your brakes don't have to work as hard. Slow down, then downshift into a lower gear prior to the descent as that's what will keep your speed under control. Keep the car in gear with your foot off the clutch and never coast in neutral as you lose all engine braking and control. Reserve the foot brake for when you actually need it as brake pads can fade if they overheat. On wet or icy roads you'll need to start to slow down earlier and downshift smoothly as an abrupt downshift can cause the rear wheels to lose grip.


By Giuseppe Frustaci | Founder & Director, Stick Shift Driving Academy


Want hands-on help? Find a Stick Shift Driving Academy instructor near you and learn with a car provided.


Key takeaways

  • Slow down and downshift before the descent starts, because that's what keeps your speed under control.

  • Stay in gear with your foot off the clutch, and never coast in neutral, because you lose engine braking and control.

  • After you downshift, check the tachometer and keep the engine out of the red zone, because over-revving can seriously damage it.

  • Use the foot brake only when you need it: engine braking supports your brakes but doesn't replace them, and brake pads can fade if they overheat.

  • On wet or icy roads, slow down earlier and downshift smoothly, because an abrupt downshift can cause the rear wheels to lose grip.


What is engine braking and how do you use it when going down a hill?

Engine braking slows you down via the engine rather than just the brakes. It's a driving technique whereby you use the engine to slow you down so the brakes aren't doing all the work.


When you're driving a manual car down a hill, ease off the gas (accelerator pedal) and downshift into a lower gear. That will give you control of your speed and you can still use the brakes if you need to. Don't shift into neutral though as being in gear is what gives you the control.


Hyundai's 2023 Elantra N manual explains the rationale: going down a hill downshifting will help to maintain a safe speed by loading the engine and will of course result in less brake wear.


How do you pick the right gear prior to the steep hills and long descents?

Before you go down any steep hills, get the right gear as it will help to keep your speed under control. If the hill is steep then go into a lower gear (second gear). On very steep descents you'll want to go even lower, into first gear.


The gear you select is going to be dependent on your speed and the type of vehicle. Downshift before you go downhill (when you can do it safely) and stay in a lower gear as you go down, as the car will go too fast if you're in a higher gear. It's much easier to control your manual car when you're in the right gear prior to the descent.


The Georgia commercial driver’s guide for truck and bus drivers makes it very clear as to why the timing is important. You need to be in a low gear before you start down the grade as once speed has built up downshifting may be impossible and engine braking will be lost completely.


What happens to engine speed and RPM when you downshift?

When you downshift the engine RPM (engine speed) will usually go up as the lower gear causes the engine to spin faster at the same speed. Before you shift, check your speed and listen to the engine. After you've shifted, check the tachometer to see what the RPM is and ensure it's in the safe zone.


If the RPM is too high, or indeed right up near redline (the red bit on the tachometer), don't go down a gear yet. Just slow down first and then shift into the right gear. The downshifting is there to give you control of the car, not to overrev the engine.


Honda's 2025 Civic hatchback manual is equally clear on the manual models: before you downshift you must ensure the engine won't go into the red zone on the tachometer as over-revving can seriously damage the engine.


The Elantra N manual includes two limits in relation to downshifting: you have to slow down prior to downshifting in order to avoid over-revving and you're not to downshift more than two gears at a time or at 5000rpm or above.


How do you use clutch control and the gearshift when you're downshifting downhill?

Downshifting is part of how you drive a manual transmission car and it's the gearshift and the clutch pedal working in conjunction.


Check your tachometer on the dash as it will show you the engine RPM. Keep that below the redline of course to avoid over-revving the engine and damaging it. Make sure your speed is appropriate for the lower gear prior to shifting so that you maintain control and can use the engine power as required.


AAA's stick shift guide is all about the clutch. When you go down a gear you need to release the clutch very slowly. That's what they refer to as clutch control. Stalling and lurching are generally the result of releasing the clutch too quickly or adding too much gas.


The bite point is where you're slowly releasing the clutch and the engine starts to take up with the wheels, so the car begins to move.


You can feel the bite point through the seat and the steering wheel, the car getting going, the engine note dropping and the revs falling.


At the bite point you'll also be aware of a low hum through the seat. If it turns into a growl or the car starts to feel strained then you've let the clutch up too far and a stall is imminent.


The bite point is in a different place in every manual car (even two of the same model) so don't expect to find it in the same place as it was in your last car.


As a novice, concentrate on smooth clutch control and finding the bite point.


Honda's manual covers the fundamentals of clutch control: press the clutch pedal right to the floor to change gears and release it slowly.


Clutch control also means keeping your foot off the pedal. The 2024 Mazda3 manual from Mazda states that you should keep your foot off the clutch pedal unless you're actually shifting, as riding the clutch will lead to wear and damage.


Without rev matching a downshift is a big drag. With rev matching you press the clutch in, give the throttle a quick blip to bring the engine up to speed with the wheels and then let the clutch up.


Rev matching on a downshift keeps the clutch from slipping, keeps the car settled and is kinder on the synchronizers in the gearbox.


Some cars will do the rev matching for you (Honda's Rev Match system for instance will adjust engine speed on gear changes). It won't do it however if it thinks a downshift would over rev the engine, so the tachometer is still your check.


How do engine braking and the foot brake work in conjunction on a long descent?

On a long or steep hill use a lower gear for engine braking and apply the foot brake as required to control your speed. Don't keep the brake pedal down as the brake pads can overheat and that can lead to brake fade.


Drivers will be able to tell when they have brake fade (the brakes have lost their effectiveness) as the pedal will feel weak and/or the vehicle will take longer to stop. If that occurs then simply slow down safely and stop in a safe place when you can.


Engine braking gives you some speed control but it doesn't in any way replace normal braking. You must always ensure your brakes are in good working order so as to avoid brake failure.


The TN driver’s manual has a tip on how to stop in a standard: flash your brake lights and then downshift to slow for the stop.


If the brakes fail the NC driver’s handbook advises you to shift into a lower gear and release the clutch in a manual, or use low range in an automatic transmission.


Why is coasting down a hill dangerous?

Coasting down a hill in neutral (or with the clutch pressed all the way down for too long) is dangerous. You lose engine braking and you have less control over your speed. You may also find yourself having to work the regular brakes much harder and they can overheat.


Instead keep your manual transmission car in the correct gear, fully release the clutch and use engine braking in conjunction with the foot brake as and when necessary. That will keep your speed under control and keep you safe on a downhill.


In Louisiana it's the law. Under the Louisiana coasting law a driver on a downgrade cannot coast with the gears in neutral or the clutch disengaged.


How do you adjust engine braking for wet roads, icy roads and winter driving?

On wet roads or on any other slippery surfaces, slow down early and use engine braking. Keep a close eye on the road surface and the road condition as you're travelling and ensure your tires have good grip.


Don't do any abrupt downshifting as that can cause the rear end to lose grip and skid. If you do find the car skidding then stay calm and steer smoothly with the wheel.


The Mazda manual is very clear about not using engine braking suddenly on slippery roads or at high speed. Downshifting on wet, snowy or frozen roads will result in sudden engine braking and the abrupt change in the speed of the tires can cause them to skid and result in a loss of control.


For timing in winter driving, the PA driver’s manual advises you to downshift prior to going downhill on icy or snowy roads for better control.


How is engine braking different in a manual and an automatic?

If you're used to an automatic car then here's what changes when you learn to drive a manual downhill; unlike an automatic transmission the gear shift is up to you.


Engine braking works in both manual and automatic cars.


In a car with an automatic transmission you can use a lower gear or indeed a special downhill mode if it has one. See your car's manual for the full details.


Whatever you're driving, don't go into neutral when you're going down a hill as you need the engine to assist in controlling your speed.


Honda's manual states that the shift down indicator will not cause a downshift for engine braking so you have to downshift yourself if you want any engine braking on a downhill.


What are the most common mistakes when driving downhill?

The common mistakes when driving downhill are using a higher gear, going too fast and constantly applying the brakes. All of those things make the vehicle harder to control and the brake pads get so hot they suffer from brake fade.


To avoid all three simply use a lower gear before you go down the hill and only use the brake pedal when you actually need to. Always be looking at the road and the traffic as that will keep you in control.


What does a genuine downhill run look like on a dry road and on a wet road?

Say you're driving down a steep hill. Get the right gear first (probably a lower gear) to help control the speed of the vehicle.


Use engine braking and apply the brakes as required. On a dry road your tires will generally have better traction but you'll still need to drive carefully.


On wet roads you'll need to slow down earlier and brake more gently as the road will be slippery. Always check the road conditions and adjust your driving accordingly. The aim is to keep a safe speed and have control of the car.


How do you stop the car rolling backwards when you stop or park on a hill?

A manual car has no Park so the parking brake is what holds it once you've stopped. AAA say to leave it in 1st if you're going uphill or on level ground and in reverse if you're going downhill.


Hyundai's Elantra N manual is equally clear: 1st gear if you're parked on an uphill slope, R if you're parked on a downhill slope and the parking brake is applied. On an incline it adds one further step which is to block the wheels.


The Colorado driver’s handbook refers to low gear when you're going up a hill with a standard transmission and reverse when you're going down a hill. It also has a curb rule: park downhill with the front wheels pointing towards the curb and uphill with the wheels turned away from the curb so that if the car does roll back it will hit the curb.


If you stop facing uphill and have to pull away again, AAA warns that the car can start rolling back while you let go of the brake to select first gear. An uphill start needs more throttle, so stalling is likelier than on flat ground. AAA's method keeps the parking brake on while you select first gear. Then, at the bite point, move your right foot to the gas pedal and release the brake as you add throttle.


Downhill quick reference

Situation

What to do

Before the descent

Slow down, then downshift before the descent starts.

On the way down

Stay in gear with your foot off the clutch, and don't coast.

After you downshift

Check the tachometer and stay out of the red zone.

On a long descent

Use the foot brake only as needed, because brake pads can overheat and lead to brake fade.

On wet or icy roads

Slow down early and downshift smoothly.

Parked on a hill

Facing uphill or on level ground, leave it in 1st. Facing downhill, leave it in reverse. The parking brake is what holds the car.


Ready to practice with a patient instructor and a car provided? Book a stick shift driving lesson at a location near you, or read our guide on 9 unusual recommendations for learning to drive a manual.



Key terms

  • Engine braking: Slowing the car with the engine so the brakes aren't doing all the work.

  • Bite point: Where the engine starts to take up with the wheels as you slowly release the clutch, so the car begins to move.

  • Clutch control: Releasing the clutch very slowly when you go down a gear.

  • Tachometer: The gauge on the dash that shows the engine RPM.

  • Over-revving: Taking the engine into the red zone, which can seriously damage it.

  • Brake fade: When the brakes lose their effectiveness, so the pedal feels weak or the car takes longer to stop.

  • Coasting: Going down a hill in neutral, or with the clutch pressed all the way down, so you lose engine braking and have less control over your speed.


The bottom line

That's how to drive a manual down a hill: slow down, drop to a lower gear before the hill starts, and stay in gear with the clutch pedal up. Watch the tachometer and stay under the redline. Press the brake pedal only when you need it, because engine braking supports your brakes but doesn't replace them.


If you'd rather have an instructor beside you, Stick Shift Driving Academy provides private manual lessons in various cities across the United States.


About the Author

Giuseppe Frustaci founded and directs Stick Shift Driving Academy (SSDA), a manual transmission driving school that operates throughout the United States. Since 2017, SSDA has helped nearly 15,000 people to discover the joy of the open road. SSDA has been mentioned in Jalopnik, Hagerty and the Detroit Free Press, and Frustaci was interviewed for the Detroit Free Press article.

Comments


bottom of page